They can be clipped in very quickly and there is far less work to do for clean cable management. The cable channels and combs are designed for 4mm sleeved cables. The fill port is at the highest point on the back for the case and the drain point at the lowest point. The reservoir was designed to remove air as quickly as possible making the loop easier to fill. The pump top was designed for the D5 pump, maximizing flow to and from the distribution plate. The integrated loop routes in Spectre allow for more flow than 16mm tubes. This meant that we could focus more on optimization than would normally be possible. With the integration we did not just develop a case, we also had to develop all the integrated components. For Spectres integration the position of each integrated port and cable routing hole was carefully chosen based on statistics and our experience. Theoretically the more integration the less compatibility. The pump and reservoir combo, less fittings, less tube, no cable combs, or cable management components. These are components you do not have to purchase for your build. Also, less fittings and tube are needed.Ĭable management is also quicker, just clip your cables into the integrated cable combs and they are all perfectly aligned.Ī large portion of the case cost is due to the integration. With the pump and reservoir combo and roughly half of the loop integrated there is less assembly to be done. 3x 8pin EPS on the left side of motherboard and up to two above the 24pin. Reservoir, D5 Pump Top, D5 Pump Cover, Fill Port, Drain Port, roughly half of the cooling loop.Ĭable management channels with cable combs. Note: Spectre 3.0 Ardus is fully compatible with the Spectre 3.0 PowerBoard and Spectre 3.0 Elite. The PSU Side and Front Shrouds both have a different design with far more detail and the PSU Front Shroud has an integrated ARGB LED strip There is a glowing logo on the back of the distribution plate. The distribution plate has twice the reservoir volume of the stock Spectre 3.0. The case can be used without the black frosted rear layer, and then it becomes a unique dark version of Spectre 3.0. These sections can be laser etched, painted, and we will be releasing different colored sets. ![]() The frosted black layer on the back of the distribution plate is divided into four separate pieces which can be removed to be modified. It is also inspired by fighter aircraft such as the F22, F35 and others. The original theme idea for Ardus was inspired by the spacecraft from the 2021 Dune film. Spectre 3.0 Ardus has a unique distribution plate with 4 layers, a front clear layer, then a black layer, then a grey tinted layer and then a black frosted layer on the back.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |